Transfer to blogspot

 I spent a few months trying to get wordpress running in a local instance to work with my ddns address but the way wordpress presents itself on just my local network, not to mention via WAN was over my head. Thus, I have decided to use blogspot which is much simpler meaning I can spend more time poasting and less time dealing with webservers. The three posts previous to this one were what I accrued on that wordpress which I have transferred here and more posts will be forthcoming.

Comments

Post a Comment

Popular posts from this blog

HF Nets

 This has been discussed before elsewhere but HF nets are so bizarre. Archaic websites. Obscure membership structures. Shooting fish in a barrel. but simultaneously inefficient where it takes one hour to get one turn.  My main gripe though is the signal reports. If you have to ask a relay for the call sign and repeat the RST multiple times, you were not a 5-5.  I'm actually enjoying this though as it helps me work out some quirks in my home set up while I get ready for more base operations. I found a net that meets late at night so I currently have something to do other than watch youtube. I'll get WAS through them I guess then got for it through LOTW.  My set up so far is the EFHW I installed in the last post which runs through the window, I placed scrap extension cord in the window track to allow the wire to slip through without crimping it while getting an almost complete seal. That goes to my Yaesu FT991A which is hooked up to the computer via USB and my Heil hea...
Read more

Low-effort Meshtastic Case Development

Image
 About a year ago I dipped my toes in some meshtastic. I saw an IO shield for a Heltec V3 and made an impulse buy of two boards without really knowing what they were. I got one running as a solar node early this year. I’m replacing that with a RAK wireless node soon so the heltecs are going in my vehicles as trackers. I needed a case to keep them organized, mountable, and protected.  HarukiToreda designed a shield for the Heltec V3 for use with Meshtastic that adds lots of IO like pinouts for GPS and environment sensors, a buzzer and more JST plugs for power. I got them on Tindie but they are still available here: https://www.pcbway.com/project/shareproject/Heltec_ESP32_V3_Ultimate_Shield_28cea98a.html. I couldn’t find a case so I remixed a simple box. I built this as a tracker going permanently in my vehicle so I wasn’t too concerned with size. It’s a little deep but that just means lots of room for activities. I use a chunk of foam to keep the board pressed against the front...
Read more